To tune in:   Analogue and DiGiTaL signals.
Your TV antenna must be pointing towards Mt. Dandenong.

• Find a unused channel on your TV receiver. (e.g. Ch 16)
• Adjust the tuning control for a TV signal, start of the UHF band.
• If you receive SBS, you have gone to far scan back.
• If you receive TEN, you've gone back to far, try again.
• If ATV is sending a TV signal your "auto tune" function may find the channel... However ATV is a low level, intermittant signal service. (not always on)
• If possible manually program your receiver for:
• DiGiTaL to 446.5 Mhz or 446500 Khz
• Analogue to 444.25 Mhz or 444250 Khz

Note:
Your TV receiver may not be able to receive ATV broadcasts because it can not pick up ATV frequencies (444 / 446 Mhz) or no one is sending a signal or the signal in your area is just too weak to receive. .. If you receive MCTV Channel 31 as a snowy or normal DiGiTaL TV as freeze / unfreeze blocky picture then ATV is most likely not receivable. Check your TV antenna and all antenna leads for good electrical / physical connection, a shake or wiggle of the plugged in leads should not cause any picture jitter or noise, if so replace item or check wall outlet etc.

aTV DiGiTaL expected on-air post September 2009.

aTV is NOT receivable if

• Your TV antenna points toward the City or you
• watch "free to air" TV services via cable TV.